Surface Forces: If The Money Is Not There, Neither Are The Ships

Archives

September 11, 2014: The U.S. Navy, faced with escalating ship building and refurbishment costs and a steadily shrinking budget has been forced to cut back on buying new destroyers as well as how much refurbishment and upgrades they can do for older ships. In late 2013 everyone was reminded that the U.S. Navy can no longer afford to build new types of  destroyers. That was when the navy finally launched the first of three DDG-1000 “Zumwalt” class ships. It will take three years to install the rest of the equipment and test the new ship before this first DDG-1000 can enter service. The new destroyer (formerly known as DD-21 or DD-X) design has a stealthy superstructure and lots of new electronic and mechanical features. It turned out to be too expensive to build more than three. DDG-1000 was supposed to be the warship of the future, but because of the cost issue it is now less clear what future ships like the new Zumwalt will have.

DDG-1000 is a 14,000 ton ship that is 194 meters (600 feet) long and 25.5 meters (79 feet) wide. The crew of 150 sailors operates a variety of weapons, including two 155mm guns, two 40mm automatic cannon for close in defense, 80 Vertical Launch Tubes (containing either anti-ship, cruise, or anti-aircraft missiles), six torpedo tubes, a helicopter, and three helicopter UAVs. The cruiser version (CGN, as Congress mandated that these be nuclear powered) would drop one of the 155mm guns, as well as the torpedo tubes, but carry more vertical cells for missiles (especially anti-ballistic missile missiles). This would be a 20-25,000 ton ship that will never be built.

In 2009 the navy decided it could only afford to build three of the new DDG-1000s. To replace the cancelled DDG-1000s the navy resumed building older DDG-51 Arleigh Burke class destroyers. It was all about cost. The DDG-1000s would cost more than $3.5 billion each if built in large quantities. The Burkes cost $1.9 billion each. The last of 62 original Burkes was ordered in 2002 and the last of those entered service in 2011. But now, another 13 are on order and more were going to be ordered until the shrinking naval budget got too tight for that. The 9,800 ton Burkes are smaller than DDG-1000, being 154 meters (505 feet) long and 20 meters (66 feet) wide. But even the Burkes have been growing, with the first ones weighing in at only 8,300 tons. In 1945, most destroyers were about 3,000 tons. This constant size escalation is something navies, especially the Americans, have had a hard time dealing with, mainly because the cost per ton has escalated even more (even after taking inflation into account).

While the DDG-51 is much less expensive than the DDG-1000, some navy officials believe that in the long run the larger and more expensive DDG-1000 would be a better investment. The key problem here is the inability of the navy to control costs, and cost estimates, and the inability of the DDG-51s to provide space for new technologies. The navy hopes to overcome this by installing smaller versions of new tech in the DDG-51s and to upgrade other DDG-51s if the new stuff works out.

There are other problems as well, such as the costs of upgrades. Because of budget cuts the navy plans to buy some time (about a decade) by upgrading dozens of existing destroyers and cruisers. This is a bitter pill to swallow, as only a decade ago the navy was so sure about the new DDG-1000 that it accelerated the retirement of a dozen of the 31 Spruance class destroyers, in order to save the $28 million a year it would cost to keep each one of them in service. These ships were not just retired, they were all either broken up or sunk in training exercises. The dozen that entered service in 1979-83 could have been refurbished and been available until 2019. That's a lost opportunity.

What can now be done is to refurb the Burke class destroyers, which began entering service in the 1990s. Most of the Ticonderoga class cruisers (which entered service in the 1980s and 90s) can use the refurb as well, which could boost their service into the 2030s. This, plus building a dozen or more Burke class destroyers, will provide an adequate number of destroyers. There is a growing debate over just how many destroyers will be required and what they must be capable of but that has to take second place to budget constraints.

Back in 2012 the refurb plan was to spend about $200 million per destroyer (and 20-25 percent more for the cruisers). Normally, these ships get one refurb during their 30 year lives. This not only fixes many of the things that break down or wear out (and been patched up) but also installs a lot of new technology. A second refurb is expected to add another 5-10 years of serviceability. But this special refurb will do more than that. The navy wants to add some of the DDG-1000 technology to these older ships. In particular, the navy wants to install the "smart ship" type automation (found in civilian ships for decades) that will enable crew size to be reduced. The "smart ship" gear also includes better networking and power distribution. In effect, the ship would be rewired. This could reduce the crew size by 20-30 percent (current destroyers have a crew of 320, with the cruisers carrying 350). In addition to considerable cost savings (over $100,000 a year per sailor), a smaller crew takes up less space, enabling the smaller crew to have more comfortable living quarters. This is a big deal as far as morale and retention (getting people to stay in the navy) goes. Most other new items are not space dependent, except for some of the power based ones (like the rail gun). But these technologies are receding farther into the future. Right now the navy has to find a way to live within its budget, and refurbishing existing warships shows more promise than trying to build affordable new ones.

In the end these extensive refurbishments were too expensive and the navy was forced to fall back on a two-tier refurb plan that concentrated on electronic and software systems. The cheaper tier, called MILSPEC (designed specifically and only for military use) cost $113 million and takes six months per ship. This upgrades a lot of the 1980s electronics in the older DDG-51s. The other tier, COTS (commercial off-the shelf) uses commercial hardware and software to replace the older MILSPEC stuff. This makes these ships easier and cheaper to continue upgrading but all this costs $184 million and 18 months per ship. All these upgrades concentrate on the ability of DDG-51s to support the Aegis modification that enables missiles and low orbit satellites to be shot down. There is additional money (from outside the navy budget) available to do this.

The navy is still in danger of losing (to retirement because of aging and failing systems) the oldest DDG-51s if money is not available to refurbish elderly hulls and mechanical equipment. Because of the unpredictable future budget the navy also has to make plans for some radical downsizing. If the money is not there, neither are the ships and prudent admirals have to plan accordingly. 

 

X

ad

Help Keep Us From Drying Up

We need your help! Our subscription base has slowly been dwindling.

Each month we count on your contributions. You can support us in the following ways:

  1. Make sure you spread the word about us. Two ways to do that are to like us on Facebook and follow us on Twitter.
  2. Subscribe to our daily newsletter. We’ll send the news to your email box, and you don’t have to come to the site unless you want to read columns or see photos.
  3. You can contribute to the health of StrategyPage.
Subscribe   Contribute   Close