The Strategypage is a comprehensive summary of military news and affairs.
 News As History - November 23, 2009




New Strategy - Wargames at Discount Prices
1.Modern Air Power: War Over the Middle East
2.Commander: Napoleon at War
3.Close Combat: Watch am Rhein
4.Gallic Wars
5.Fast Action Battle: The Bulge

100+ Computer and Board games all with free shipping.
 
 
 
Military History | How To Make War | Wars Around the World Rules of Use
How to Behave on an Internet Forum
Dirty Little Secrets Discussion Board
Sign In   Return to Topic Page
Subject: Spray-On Armor
James Dunnigan    8/14/2004 11:58:16 PM
U.S. Navy researchers have discovered that polyurea, a high strength, spray-on plastic normally used to provide a non-skid surface on ship decks and truck beds, and for corrosion control, also absorbs the blast effects of bombs. About 3-4mm of polyurea was sprayed on the outside of a hummer and then a bomb was set off next to the vehicle, to recreate a roadside bomb attack in Iraq. There was much less damage inside the vehicle than when the same bomb was set off next to a hummer without the polyurea coating. The polyurea also prevents the metal body of the vehicle from splintering and turning into dangerous fragments. Had there not been a war going on in Iraq, that featured frequent attacks on unarmored vehicles, this unexpected use of polyurea would probably never have been discovered. The navy might end up coating the top side of small surface ships with the stuff, to give the crew additional protection in the event of missile or bomb attacks. The air force and army are also using polyurea as a wall coating for buildings that might be bombed. Tests have shown that the polyurea coating greatly reduces the bomb damage. Coating a hummer would cost several thousand dollars.
 
Quote    Reply

Email Me When A New Comment Is Made
Show Only Poster Name and Title     Sort in Reverse Order Posted

gf0012-aust    Spray-On Armor   8/15/2004 12:23:29 AM
Hasn't this been posted on here before - or is it in one of the armour topics?? Either that or I am subscribed to too many military technology sites. ;) I think you'll also find that there are critical areas in the Pentagon that have been coated in "Rhino" as well. (since 9-11)
 
Quote    Reply

Bigbro    RE:Spray-On Armor   8/22/2004 5:25:08 PM
gf0012-aust pointed out that we have covered this already. 500 F is the operating limit for the material.
 
Quote    Reply



StrategyWorld.com© 1998 - 2009StrategyWorld.com. All rights Reserved. StrategyWorld.com, StrategyPage.com, FYEO, For Your Eyes Only and Al Nofi's CIC are all trademarks of StrategyWorld.com Privacy Policy